How do i activate hwaudit and swaudit

[htaute]

I have installed Opsi v3.3 on a VM server and ran service_setup.cmd on my pc. In the Opsi Config editor i see that my pc was added as a client. How do i activate hwaudit/hwinvent and swaudit as i cannot seem to gather it out of the installation manual?

[wolfbardo]

see chapter

3.2.6. Product configuration

for hwaudit/swaudit

and

3.2.7. Netboot products

for hwinvent

in the opsi-manual-v33-en.pdf

regards,

Bardo Wolf

[htaute]

In the Product Configuration the installation_state is not_installed. Must i change it to another state and must i change the action_request as well?

[wardenik]

No, just change the action to setup.

[j.schneider]

You have to set an action request.
The instllation status is always the result of an action performed.

[htaute]

I have done as suggested ie changing the "action request" for hwaudit, swaudit and python to setup but still no joy. If i change the :installation state" to installed it actualy gives me the version and package. They say Python is a prerequirement for hwaudit and swaudit.

[wolfbardo]

They say Python is a prerequirement for hwaudit and swaudit.

It is.

You have to set an action request.

and save inconfiged.

Restart your opsi-Client and pheck/post c:\tmp\logoblog.txt and c:\tmp\instlog.txt

regards

Bardo Wolf

[htaute]

Thank you all for your patience and assistance. Bardo, I looked at the logonlog.txt and saw that there was no WINS entry for the server so it could not connect to the share to do the setups required. After creating a WINS entry everything ran well. Thanks again.
Regards
Henri Taute