forum.opsi.org

Hi
I have a problem with some computers during the installation of Windows Seven x64.
During installation, the setup.py script creates two partitions (1 NTFS of 14 Giga, and 1 FAT32 of 4 Giga)
But at the end of the installation, partitioning is not recreated.
The hard drive is an SSD.

(Version of Opsi : 3.4 ; i think i will upgrade during july !!)
Thanks for the help

Olivier

Hi,

opsi 3.4 is not supported. Especially the support for SSD Harddisk (alignment) is much better in a actual opsi Versions. Please make first a upgrade to actual opsi 4.0.1 and try again.

regards
e. ueluekmen