forum.opsi.org

Hi,

I am having problem while Windows XP installation on my Dell 280. Linux part is ok but the setup stops working during network installation and configuration. I was trying to use old drivers from unattended which are working there and I also tried new drivers as well. Do you know where the problem can be? I am starting to be hopeless that it can work.
Thank you in advance.

Regards,
Pavel

paja hat geschrieben:Linux part is ok but the setup stops working during network installation and configuration.

what does tis exactly means?
- please post/check the bootimage-log of the client and the output of showdrivers.py <fqdn of client>
- check client memory size
- try some of kernel parameters like acpi=on/ off:
Select the client in configed and go to host parameter tab.
Select Property opsi-linux-bootimage.append and add the parameter your are testing


regards,
Bardo Wolf

wolfbardo hat geschrieben:

paja hat geschrieben:Linux part is ok but the setup stops working during network installation and configuration.

what does tis exactly means?

First part of installation is done in linux, Windows installation itself starts after the first restart and this Windows part stops working during network setup which comes after hardware installation.

wolfbardo hat geschrieben: - please post/check the bootimage-log of the client and the output of showdrivers.py <fqdn of client>

In attachment.

wolfbardo hat geschrieben: - check client memory size

Memory is ok.

wolfbardo hat geschrieben: - try some of kernel parameters like acpi=on/ off:
Select the client in configed and go to host parameter tab.
Select Property opsi-linux-bootimage.append and add the parameter your are testing

I have tried all possible options - acpi=off, irqpoll, noapic and their combinations.

Thank you for your time.

Pavel

Hi,

you are using a driver from the driverpacks: Dell often customize their chips, so you have to use the dell driver.
Place the dell driver in the preferred directory , run create_driver_links.py
and than try show_drivers.py again.
Now the dell driver should be selected.
If this is done - retry the OS Installation.

regards
d.oertel

d.oertel hat geschrieben:Hi,

you are using a driver from the driverpacks:

Code: Alles auswählen

[11AB:4320]  Marvell Technology Group Ltd. : 88E8001 Gigabit Ethernet Controller
      /opt/pcbin/install/winxppro/drivers/drivers/D/L/M

Dell often customize their chips, so you have to use the dell driver.
Place the dell driver in the preferred directory , run create_driver_links.py
and than try show_drivers.py again.
Now the dell driver should be selected.
If this is done - retry the OS Installation.

regards
d.oertel

Hi,

I have already tried official Dell drivers, DriverPack drivers and also drivers from unattended which work perfectly there.

Pavel

Hi,

also drivers from unattended which work perfectly there

opsi does nothing special with the drivers: They are copied to the hard disk an the path to the driver is added to the OEMDriverpath in the unattend.txt.

regards

d.oertel

Problem solved. Installation stopped working during network configuration, but I had to change video card driver instead. Now is everything working.

Pavel