forum.opsi.org

executing

./opsi-deploy-client-agent -vv -r simlab8

I am getting an error

[error] ERROR: Failed to install opsi-client-agent: Command './winexe -U 'Administrator369Oprize4U' //simlab8.cr1534.sims 'c:\opsi_PbhKTEN8ml\files\opsi\opsi-winst\winst32.exe /batch c:\opsi_PbhKTEN8ml\files\opsi\setup.ins c:\tmp\opsi-client-agent.log /PARAMETER REMOTEDEPLOY'' failed (1):
ERROR: Failed to open connection - NT_STATUS_NO_MEMORY

1) I didn't use the -c option, so why is it using the fqdn for the hostname?
2) The password is NOprize4U so it should be passing 'Administrator%NOprize4U' instead of 'Administrator369Oprize4U' shouldn't it?

Hi,

tinjaw hat geschrieben: 2) The password is NOprize4U so it should be passing 'Administrator%NOprize4U' instead of 'Administrator369Oprize4U' shouldn't it?

yes i think so. It seems that there is a escaping problem in the script.
Perhaps try a other password ......

regards

d.oertel

I am using a simpler password, and I believe that portion of the problem is resolved. However, I am still getting the error NT_STATUS_NO_MEMORY and it is still using the fqdn even though I am not using the -c option.

I have experienced the exact same problem once, solved it by using the hostname without the domain suffix.
Had to manually edit the deployment script, but this basicly solved my NT_STATUS_NO_MEMORY issue.

If you want to try it out, open the script at "\opt\pcbin\install\opsi-client-agent\opsi-deploy-client-agent" and locate this portion of the script (around line 89):

Code: Alles auswählen

def winexe(cmd, host, username, password):
	cmd      = forceUnicode(cmd)
	host     = forceUnicode(host)
	username = forceUnicode(username)
	password = forceUnicode(password)

Add the following line anywhere after "host = forceUnicode(host)":

Code: Alles auswählen

host     = host.split('.')[0]

It should now look like this:

Code: Alles auswählen

def winexe(cmd, host, username, password):
	cmd      = forceUnicode(cmd)
	host     = forceUnicode(host)
	host     = host.split('.')[0]
	username = forceUnicode(username)
	password = forceUnicode(password)

Now try to run the script and post the results.

Hi,

thank you for the hint - it is incuded in the next update.

regards

d.oertel

forum.opsi.org

error using opsi-deploy-client-agent

error using opsi-deploy-client-agent

Re: error using opsi-deploy-client-agent

Re: error using opsi-deploy-client-agent

Re: error using opsi-deploy-client-agent

Re: error using opsi-deploy-client-agent