Is it possible to set the scope for the opsiclientd-control-port?

Antworten
EricT
Beiträge: 20
Registriert: 18 Nov 2011, 12:49

Is it possible to set the scope for the opsiclientd-control-port?

Beitrag von EricT »

hi,

during client-installation the opsiclientd-control-port is added, but the IP-address of the depotserver is not set in the scope of the rule.

If I add it manually after the installation, a reboot or opsiclient-service restart removes the IP-address from the scope.

Is it possible to add the IP-address of the depotserver to the scope of the opsiclientd-control-port? For instance during client-install using a config-file?

Thanks.

Regard, Eric
Benutzeravatar
SisterOfMercy
Beiträge: 1522
Registriert: 22 Jun 2012, 19:18

Re: Is it possible to set the scope for the opsiclientd-control-port?

Beitrag von SisterOfMercy »

Uhh.. Do you mean the firewall port on windows for the opsi-client-agent?
Bitte schreiben Sie Deutsch, when I'm responding in the German-speaking part of the forum!
EricT
Beiträge: 20
Registriert: 18 Nov 2011, 12:49

Re: Is it possible to set the scope for the opsiclientd-control-port?

Beitrag von EricT »

hi SisterOfMercy,

correct.
The firewall on the clients are active because of the network-environment.
During the installation of the opsi-client a rule called opsiclientd-control-port is added to the firewall of the client, but the scope isn't set for this rule.

I was wondering if I can set the scope for this rule to the IP of the depotserver, to limit access.
At the moment the scope is emptied during a reboot or by a restart of the opsiclientd-service on the client.

Thanks.

Regards, Eric
Antworten