Seite 1 von 1

call HW scan manually

Verfasst: 05 Jul 2017, 15:35
von ariedederde
Hi,

currently investigating opsi. Have one windows 7 test client that already existed in the opsi config editor. Hardware information, software information is empty. How can I force an update on the client from the config editor to get this data?

Thanks,
Arie De Derde.

Re: call HW scan manually

Verfasst: 05 Jul 2017, 15:50
von r.roeder
you just have to set action request for the product hwaudit resp. swaudit to setup and restart or initiate a "on_demand"-event (e.g. via the context menu in the product table)
Enjoy
Rupert

Re: call HW scan manually

Verfasst: 05 Jul 2017, 16:25
von ariedederde
Hi Rupert,

I have been scanning the manual on how to set this, but I can't find it. Can you please tell me where and how to set this?

Thanks in advance,
Arie.

Re: call HW scan manually

Verfasst: 11 Jul 2017, 17:47
von ueluekmen
Hi,

have you deployed the opsi-client-agent? If not, please check the first steps in opsi-getting-started manual.

Re: call HW scan manually

Verfasst: 18 Jul 2017, 12:33
von n.wenselowski
Hi Arie,
ariedederde hat geschrieben:I have been scanning the manual on how to set this, but I can't find it. Can you please tell me where and how to set this?

It can be found in the getting started here.


Kind regards

Niko